Have you installed an Amped WiFi range extender in your house? But, why there are stress lines on your forehead? Is your Amped WiFi extender not getting IP address? Worry not! This post covers all those Amped wireless extender troubleshooting tips that will help you get the issue resolved in a matter of minutes. So, let’s get going.
Fixed: Amped Extender Not Getting IP Address
-
Reboot the Extender
Before you do anything else, consider giving a fresh start to your Amped wireless extender. At times, technical glitches are restricting your Amped WiFi extender from getting the IP address which can be fixed by rebooting.
To reboot your Amped wireless range extender, consider following the instructions given below:
-
Switch off your Amped extender and unplug it from its respective wall socket.
-
Let the extender sit without power for a few moments.
-
Re-plug the Amped extender back into the wall outlet and switch it on.
-
Check Extender-Router Connection
Perhaps, the Ethernet cable connection between your Amped extender and the host router has become weak. Is the Ethernet cable you’ve used in perfect condition? Is the condition finger-tight? If you are unable to fulfill the former condition, then replace the current Ethernet cable with a new one. If the latter one is the case, then ensure that the Ethernet cable is tightly connected to the ports of your WiFi devices.
In case you have used a wireless source to establish a connection between the Amped extender and router, then ensure a safe distance between your devices. The extender should not be placed beyond the boundary line of signals emitted by your host router. However, your WiFi devices should never stick to each other. After mending the connection between your WiFi devices, try to access the Amped wireless range extender login page to verify whether the issue has been fixed or not.
-
Change the Extender’s Location
The extender’s poor placement can also force you to face the Amped WiFi extender not getting IP address issue. Have you placed your Amped extender correctly? Oh, it seems that your Amped extender is placed inside an almirah. Well, it is restricting your extender’s WiFi signals. Therefore, bring your WiFi extender to the open space.
Additionally, your Amped range extender must not be placed near mirrors, fish tanks, metal studs, microwave ovens, televisions, refrigerators, smart watches, Bluetooth speakers, lenses, glasses, etc. Avoid keeping the WiFi extender near thick concrete walls.
-
Contact Your ISP
The Amped Extender might also fail to get the IP address if there is an issue from the end of your Internet Service Provider. Perhaps, he is not doing his job properly.
Therefore, consider giving a call to him and verifying whether there is an internet outage in your area. If he agrees to the same, then wait for some time and let him get the internet issue resolved.
-
Reset the Extender
If none of the aforesaid troubleshooting techniques has worked in your favor, then there are high chances that your Amped extender is improperly configured. It means you have to set up your Amped range extender again. But, before that, consider restoring it to the factory default mode.
Therefore, without any delay, start looking for the Reset button on your Amped WiFi extender and press it once found. Within a minute or two, your Amped WiFi extender will start running on the factory default settings. Now, access http://setup.ampedwireless.com to set up Amped extender.
Final Words
That’s all about what to do if you are facing the Amped WiFi extender not getting IP address issue. Hopefully, you will be able to get the issue resolved with the help of the troubleshooting hacks mentioned in this post. Did you like reading the post? Do share your thoughts in the comment section.